Happy Happy Happy !!!!!
I received this from Baum Software
Hi Ron,
first of all you should find out, whether the pedal of your DGX is sending always the same controller and value.
If you could set it to specific controller who „does not hurt“ your playing in a musical way, then it shoul be relstively easy.
Just check, which value is sent while parading your pedal. Therefore I would use the midi monitor which you will find in the … menu, if no song is opened in SB+.
Then if you know this, you could go to the settings of SB+ => foot pedal => midi foot pedal => freely configurable ControlChange=> and there you may configure it as you want.
Please let me know if it works.
Good luck!
Best regards,
Elmar Pürkenauer
BauM-Software Support Team (SongBook+)By using the "Songbook+ Midi Monotor", I was able to determine that:
Right Hand Pedal uses Controller 64
Middle Pedal uses Controller 80
Left Hand Pedal

?? could not find any Contoller Numbers
I did not want to change the Sustain Pedal so I choose the middle pedal to turn pages.
To set it up: Settings>Foot pedal>MIDI foot pedal>Freely Configurable ControlChange>80>3>execute Jump to next page
This works for me
RonP