Author Topic: Aux Fed Sub-Woofer Technique  (Read 5743 times)

0 Members and 1 Guest are viewing this topic.

Offline mcbrown

Aux Fed Sub-Woofer Technique
« on: March 29, 2020, 03:54:37 AM »
I found this article on the internet which some of you tech people may find interesting and you may see a use for the concept in your gigs.

Genos + MS01, TouchMix 30 Dig Mixer, Fender Strat & Tele, Cole Clark FL3, Music Man 210 75 and Behringer: FCB1010, B1200D Subs x 2 & B205D f/b spkrs x4, Boss: GT-1 Guitar Fx, Roland: GR-55 Guitar Synth, MAUI 28 G2 & 5 GO x2, Korg EK-50L Arranger, Zoom L-8
The following users thanked this post: t4inbax

Offline jimlaing

Re: Aux Fed Sub-Woofer Technique
« Reply #1 on: September 01, 2020, 06:41:35 AM »
Back when my 6pc band did larger gigs (esp. outdoors), we used this technique to good effect.  We just used AUX send controls on the mixing board, to control which channels had some signal sent to the subwoofer.  Usually it was just bass guitar, kick drum, and maybe keyboards since some synths/effects do have some low-frequency 'energy' in them.  We'd leave out vocals, acoustic and electric guitars, so that those signals didn't muddy up the mix (even though those typically don't have a lot of LF energy.  Was fairly simple to set up, and worked OK.  The AUX out for the AUX channel we used, was sent directly to the subwoofer amps.  The main mix (L and R) went to those amps.  Nothing much fancier than that ... 

Raleigh, NC, USA / Genos / Tyros5-61 / Lucas Nana 600 / other stuff