... When i select Part 3 it knocks out parts 1 & 2 so can only play 2 selections at the same time instead of 3
Is there a setting somewhere that i am missing to make all three parts work at the same time.
Mine is a second hand unit so wondering if a setting had been locked in somewhere before i purchased it. ...
Hi Trecker,
this is a Split Point "problem":
Press [Direct Access] > [Sync Start] (in the Style Control section) to call up the Split Point display. Make sure that the
RIGHT 3 Split Point is set
one semitone higher than the LEFT Split Point here. (Usually the
STYLE and
LEFT Splitpoints are set to "
F#2". To can play all three RIGHT Parts at the same time, the
RIGHT 3 Split Point must be set to "
G2" then.)
Press [Exit] button. This will automatically save your settings to the "System Setup". But be aware: The Split Point settings can be changed again when using Registrations. (When creating a Registration, the currently set Split Points are also saved (STYLE and LEFT Split Points with the STYLE groop, RIGHT 3 Split Point with the VOICE group).
Additionally I recommend to check the "
Parameter Lock" settings: Press "[Function] > Config 1" and go to "3 Parameter Lock".
If "Split Points" is checked here, the Split Point settings can only be changed as described before, but can NOT automatically be changed by Registrations or MIDI files. So, if you want to work with
different Split Point settings (and change it by Registrations), do NOT check the "Split Point" box here.
Same for the "Fingering" settings: If you want to use
different settings, do NOT check the "Fingering" box in Parameter Lock.
By the way: I recommend to always leave the "
Master EQ" box
checked in Parameter Lock. Otherwise your Master EQ settings could be accidentally changed by MIDI files.
Hope this helps!
Best regards,
Chris