Hello
How do you program the two pedal ? I could configure all other 10 buttons without the two pedal.
Thanks
The right pedal is already assigned to Control Change 7 (CC7)
The left pedal is standard assigned to CC27 so you have to change that to CC4, to do this do the following steps:
- Press the down button for 5 seconds
- Press the up button
- Now press Pedal 8
- Press the up button again
- now enter the number 04
- Press the up button again
- Press the down button for 5 seconds
Done
Now you can assign any function on the genos settings for CC4 to your left pedal
For the right pedal you have to assign a function on the genos for CC7 (for instance upper 1 volume)
het rechter pedaal staat al goed die is gekoppeld aan CC7 die staat ook in de genos external control en bedient nu upper 1 volume. Het linker pedaal moet je veranderen van CC 27 naar CC 04. Dat werkt op dezelfde manier, houd down 5 sec ingedrukt, daarna druk je op up. Daarna op pedal 8 , vervolgens weer op up. Nu kun je het getal 04 invoeren, druk weer op up om te bevestigen en houdt daarna down weer 5 seconden ingedrukt. Nu kun je in de genos bij CC4 het linkerpedaal ook toekennen