OK...this is one of those where forward planning may have helped. I have had the Genos for 12 months and in that time have compiled a list of about 200 registrations - all with about 5 or 6 (or more) registration buttons configured for. When I save each registration button and bank I used the Genos Default Settings - which means that a: Assignable Button F is "not assigned" and that the foot pedal 1 is used as a fill. All this was OK when I did not use these assignable buttons and did not have a foot pedal but since I have added these its all gone pear shaped.
My default setting is that Pedal 1 is used as a Sustain and that I have assigned Button F as a Fade Out - this works fine until I then select a registration bank at which point button F is no not assigned and the foot pedal no longer works as a sustain but as a fill in.
I order to correct this I have to load my registration, then go in a change the Button F and also the Foot Pedal settings, this is several presses on the touch screen and is very time consuming and frustrating as not only do I have to do it for each registration bank (song) but each button in that bank, so with over 200 registration banks each with upwards of 5 settings that means have to make the changes over 1,000 times - NIGHTMARE. Wish I had know this when I first stated using the Genos
So, question: Is there a simpler and quicker way of doing this so that my preferred setting stay as I want them (F = Fade Out and Pedal 1 = Sustain) or is there a way I can prevent the registration changing my Assignable Button and Pedal Settings when I select or change registrations. If not, I suspect I have several hours of mind numbing frustration ahead of me to change each and every registration individually.
I have since set up my save so as not to save these setting (unchecked the boxes).
Hope someone out there much smarter than me can help.
Thanks
David