Author Topic: Want no pitch-change or chord-follow of a Multipad?  (Read 827 times)

0 Members and 1 Guest are viewing this topic.

Offline ton37

Want no pitch-change or chord-follow of a Multipad?
« on: December 28, 2017, 03:19:22 PM »
I want a multipad-sound (kind of arp-sound, not a audio-mp) that remain in the same 'tune', so no pitch or following the chord (ACMP). Is there a function to setup the multipad. In a former keyboard (a technics) I remembered that it could be setupped. For the T5 I cannot find it? It looks that the manual says it cannot be done? If that is true, so be it... >:(
Regards Ton
 

Offline Seagull29

Re: Want no pitch-change or chord-follow of a Multipad?
« Reply #1 on: December 28, 2017, 04:30:52 PM »
Hi,
load or select  your Pad, select Edit and make all parameters of it off, then save.
 

Offline ton37

Re: Want no pitch-change or chord-follow of a Multipad?
« Reply #2 on: December 28, 2017, 04:54:11 PM »
Thanks for your reply Segull29, I loaded one from my HD,  but in MP-Edit-menu I only can 'delete or copy', I see no menu to change parameters?
 

Offline tyrosaurus

Re: Want no pitch-change or chord-follow of a Multipad?
« Reply #3 on: December 28, 2017, 05:13:04 PM »
To do this you need to load the relevant MP bank, and then open 'Multi Pad Creator' (press CREATOR > MULTI PAD CREATOR).!

Once open, at the bottom of the screen you will see options for 'Repeat' and 'Chord Match' for each of the four pads in the bank.

It is the 'Chord Match' setting that you need to set to 'Off' to prevent the pads from following chords.

Set as appropriate for each MP, then save the bank to make your changes permanent.

Note that MPs using non drum voices will still be transposed if the keyboard is transposed even with Chord match turned off, but will not follow chords played.


Regards

Ian
 
The following users thanked this post: ton37

Offline Seagull29

Re: Want no pitch-change or chord-follow of a Multipad?
« Reply #4 on: December 28, 2017, 06:15:02 PM »
Sorry, I forgot the "MultiPad Creator" ! :(
 
The following users thanked this post: ton37

Offline ton37

Re: Want no pitch-change or chord-follow of a Multipad?
« Reply #5 on: December 28, 2017, 07:08:00 PM »
Thanks tyrosaurus for your detailed explanation. I had not used the Creation function yet. It works well now thanks to your help.
@Seagull29, thanks anyway, I presume your solution would have gone in the same direction tyrosaurus pointed at.

Regards Ton