PSR Tutorial Forum
The PSR Tutorial Forum (5 Boards) => Forum How To Focus => Topic started by: Normanfernandez on December 07, 2018, 04:03:43 PM
-
I want to set Wave 1 and Wave 2 ( to have equal volume) according to the velocity.
In this current setting ( Default )
Velocity 1 - 60 Ish goes from
Almost zero to Loud. And 61 - 127 is Loud to Very Loud.
I can Adjust the Max Volume for the Higher Velocity for Each Wave.
But How can adjust the Volume
For lower Ranger Velocity
Say 1- 20
This Range Will Very Soft.
My 2nd Problem is.
IF i Hold the Note Down Any Note that Contains the Wave.
" Hold it Long Enough " the Sample Wave Starts Playing Again.
If you don't understand this Problem.
I'll break it down more.
Please Help
Regards Norman
[attachment deleted by admin]
-
Hi,
I think you can try to make each wave in a different element (wave 1 in element 1 and wave 2 in element 2) and put equal volume on or mix them.
Regards
Seagull29
-
You can also mix elements from different voices which is great fun to do.
-
adding element 1 and 2 would make the voice play two Different wave files at the same time.
Which is different from what I want.
I want all the Wave files on a Single Note ( C3)
To have the Same Volume regardless of Velocity.
-
"I want all the Wave files on a Single Note ( C3)
To have the Same Volume regardless of Velocity".
You can remove touch sensitivity from the overrall voice (either in YEM or later in Voice Set) simply enough by setting the Touch Sensitivity Depth to 127.
"adding element 1 and 2 would make the voice play two Different wave files at the same time."
If that is the only objection (and bearing in mind I do not understand from your first post what you are trying to achieve) you can put a copy of the same wav into both but you may need to pan them differently to avoid chorusing effects.
John