PSR Tutorial Forum
Genos (12 Boards) => Genos - General => Topic started by: Murat on April 22, 2019, 12:51:56 PM
-
Is there an easier way to swap between R1, R2 and R3 rather than actually pressing the buttons (Part on/off)? Does anyone use pedals to do this? Any thoughts please?
-
Murat, you could set Registrations 1, 2, and 3 to activate R1, R2, and R3. Those buttons are much closer and easily accessible. Make sure the background settings are all the same, except for the R button values.
-
And once you start using those registrations fully, then you can start using registration sequences operated by pedal, rather than pushing buttons.
-
Good one, Andy. I forgot about that. You da man!
-
And once you start using those registrations fully, then you can start using registration sequences operated by pedal, rather than pushing buttons.
Or just use your mfc10 pedal to switch r1, r2 and r3 directly?
There is so many things you can do on Genos to get where you want..
You could also create 3 OTS settings for this...but i agree performances work better for this..
-
Is there an easier way to swap between R1, R2 and R3 rather than actually pressing the buttons (Part on/off)? Does anyone use pedals to do this? Any thoughts please?
As R3 is different from R1,R2 concerning the split point, and for smoother switching reasons (it's better to keep the same sound and DSP configuration between registrations), I would like this feature too.
-
Yes ... Registration buttons .. and sequence pedal control is way to go.