PSR Tutorial Forum
Genos (12 Boards) => Genos - General => Topic started by: tyrosrick on February 08, 2023, 10:05:07 PM
-
I know Overover had this topic solved a couple years ago, but thought I would FYI it for an other Newbies besides me: I had accidently/unknowingly turned ON the Registration Sequence light. After that I noticed my foot pedals were either dead or acting weird. Then I noticed Overover's thread and turned OFF the Reg Sequencer light and now pedals are back to the normal way. This is just a point of info I thought I'd share.
-
Hi Rick,
Yes, as often mentioned, unfortunately you can only activate or deactivate the Registration Sequence function globally, but you CANNOT memorize its settings and its On/Off status to Registrations.
If you want to use the Registration Sequence function, I recommend using only ONE pedal for this: Assign "Regist+" on the Genos to e.g. Pedal 2 and set "Regist-" to OFF. So you can still use pedals 1 and 3 as normal.
By the way, you can also use the [DEC]/[INC] buttons on the Home display or the ASSIGNABLE buttons to step through a Registration Sequence.
Best regards,
Chris
-
Hi Rick ,
I have been using foot switches for 15 years on Tyros and Genos and I am a big fan of Sequences.
At first I used 2 switches, one to go forward an one for the backward action, but then I found out that if you plan your Sequence carefully, you only need the forward action.
That frees up a foot switch and I use that one for other actions like; insert Breaks, Stop, Sync Stop, play MultiPad and a whole list of other actions. I try to avoid moving my left hand over the keyboard to push the MultiPad buttons! A foot switch is a big help here.
And if I need more than 10 registration buttons I can jump to the next registration and continue the sequence. On my sheet music I put red notes for sequence actions like S1, S2... and for left pedal actions I use LP.
I have some clips on YouTube where you can see these sequence actions: https://www.youtube.com/c/StijnBettens/videos
Regards,
Stijn