Hello All,
I seem to be having a problem with the recognition of chords that are being detecting by incoming midi signal to my S770. My setup is a Technics GA3 as the master controller keyboard with the lower manual feeding channel 2 for arranger chord detection. I have never had any issues with the correct chord being recognized over the last 2 years but all of a sudden the PSR is showing 3 finger major chord adding a 5th or 7 th or not interpreting the chord correctly. Sometimes the chord will not even change (remains as an F with C being played). And sometimes the display shows something like " cancel/G+5" , don't have a clue what the cancel means. The Technics display is reading the correct chord. I have reset and reconfigured both the Technics and Yamaha and set the PSR for fingered mode on chord type. I have even changed out the midi cable but have the same results. Have gone over the configuration for both keyboards many times and just cant pinpoint the problem, any suggestions is appreciated. I am going to connect Midiox to the technics output to check that midi data is being transmitted correctly.